Hougen HMD904 Portable Magnetic Drill

Description

Hougen HMD904 Portable Magnetic Drill Version 0904103 with swivel base
Any excess shipping payed will be refunded.
Includes Hougen 11/16” “12,000 Series” 12222 annular cutter & pilot.
2” depth of cut
Drills materials up to 275 BHN. This M2 H.S.S. cutter features a 3/4-inch diameter shank, and is made of hardened, high speed tool steel and precision ground.
The included bottle of RotaMagic cutting fluid is super concentrated & requires the bottle to be filled with water & shaken before use.
Specifications:
Cutter Type........................Hougen "12,000-Series" and Copperhead™ Carbide
Hole Capacity....................7/16" to 1-1/2" (12mm-38mm)
Depth of Cut......................2" (50mm)
Twist Drill Capacity............1/2" w / Drill Chuck (not included)
Tapping Capacity...............1/2" w / Tapping Unit (not included)
Motor.................................450 RPM, 8A, 920W (115V)
Swivel Area.......................1-1/8" W x 1-3/8" L (28.5mm W x 34.9mm L)
Reversible feed handles
LED pilot light - to illuminate the work surface area for easier viewing of cutter pilot
Net Weight........................30 lbs. (13.6 kg)
***WARNING: Never pull away with the feed handle, from the work surface with
the motor on. Always turn the motor off then pull away ***
Material must be a least 3/8" thick. Material thinner than 3/8" will cause a "weak" magnet condition.
For this non-coolant bottle drill, fill arbor reservoir by introducing RotaMagic™
cutting fluid through slots in the arbor. Cutting fluid should not leak out.
Test metering capabilities of Arbor / Cutter / Pilot assembly (magnet ON – motor
OFF) feeding the Arbor gently toward work surface until pilot is pushed up into
Cutter, thus allowing fluid to filter down onto work surface through groove in
pilot.
Non-Coolant Bottle Drills
For proper lubrication, all fluid in reservoir should empty onto work surface in no
less than 15 seconds and no longer than 30 seconds.
Arbor Reservoir holds enough coolant for cutting approximately one hole.
For horizontal or drilling overhead holes, use Slick-Stik™ Lubricant or RotaGel™
#1 cause of cutter breakage and prematurely dull teeth is too little feed pressure